迷你符合性設備，適用于小抓持器

? X-Y 及 α 角符合性[1]。

? 在方向 Z 為剛性。

? 一根空氣導管連接至中央零位 [2]。

? 另一根空氣導管可鎖定任何偏移位置 [3]。

Mini compliance device, for small grippers

? X-Y and angle α compliance [1].

? Rigid in Z direction.

? One air lead to get the central zero psition [2].

? Another air lead to lock in any offset psition [3].

編程單個SB8F

在對傳感器盒進行編程之前，請確保有線輸入處于所需配置（開/關）以啟用輸出。按下AUTOSET按鈕并按住3秒鐘，直到READING紅燈開始閃爍，然后松開。紅燈（READING）閃爍表示微處理器正在讀取和存儲全部輸入的狀態。然后紅燈熄滅，啟用了輸出。黃燈（STORED）指示啟用輸出。

Before programming the sensor box, make sure that the wired inputs are in the confguration (ON/OFF) desired to enable the output. Press the AUTOSET button and hold it down for3 seconds until the READING red light starts fashing, then release it.Thered light (READING) fashing indicates that the microprocessor is reading and storing the state of all the inputs. Then the red light goes off and the output is enabled. Output enabling is indicated by the yellow light (STORED).

雙鉗口自動校準平行i氣動鉗夾(SZ系列)

?雙作用。

?彈簧關閉；如需要時彈簧打開 。

?多種的緊固和輸送選項。

?可選的磁傳感器。

?FDA-H1 食品級潤滑脂。

?不銹鋼顎式鉗。

?Double acting.

?Available with normally closed or normally open spring on

request.

?Various options for fastening and feeding.

?Optional magnetic sensors.

?FDA-H1 food-grade grease.

?Stainless steel jaws.